Apollo Triple Bend (Double Bend Offset + Lie) Putter Shaft

Rating:
100 % of 100
$8.50
In stock
SKU
AP46CP-001
More Information
Display Price 8.50

The Apollo Triple Bend Putter Shaft is intended for 90 degree bore hole (or post) putter heads. This means that if you have a putter head with a hole drilled straight down from the putter head, and the hole is for a .370 shaft, this shaft should work for you. However, if you have a putter head with a hole drilled at an angle into the putter head, this shaft is NOT the shaft you want. 

More information about a "triple bend" putter shaft: This shaft may have a butt label that describes it as “Double Bend (offset + lie)”, but this is more commonly known as a triple bend by putter manufacturers, lie angle being the third bend. In other words, straight up from the 90 degree hole, one bend to create offset, one bend up, and one bend toward the player to create a standard putter lie angle.

Raw length on this shaft is 35"

Customer Questions
I'll need a extention for this shaft. What do you recommend.
This one would work well:  Steel Shaft Extender for .600 Steel Shafts
Basic question, but are there trimming instructions for this shaft? Not sure if I should trim any amount from the tip or butt trim only. I'll be installing in the Bionik 504 putter head.
No need to tip trim any of our putter shafts under normal circumstances. You can just install and then butt trim to length.
What is the inner diameter of this shaft so that I can determine how large the post needs to be?
The shaft will go over a .325 post (which is quite standard)
Is shaft smooth or stepped
This putter shaft is stepped. Every putter shaft on our site that doesn't say "stepless" is a stepped shaft.
What is the lie angle created by this shaft? and also What is the offset created by this shaft?
Lie angle created is 72 degrees. Offset is 1/4"
Write Your Own Review
You're reviewing:Apollo Triple Bend (Double Bend Offset + Lie) Putter Shaft
Your Rating