The Apollo Double Bend Putter Shaft fits angled bore hole (or post) putter heads. This means if you have a putter head that has a hole drilled at an angle into the putter head (70-73 degree angle) and the hole is .370, this shaft should work for you. If you have a putter head with a 90 degree hole (a hole drilled straight down) this is NOT a shaft that will work for you. This shaft provides offset to place the shaft in front of the putter face.
Works in right or left handed putter heads.
Product Questions
Customer Questions
I'll need a extention for this shaft. What do you recommend.
This one would work well: Steel Shaft Extender for .600 Steel Shafts
Basic question, but are there trimming instructions for this shaft? Not sure if I should trim any amount from the tip or butt trim only. I'll be installing in the Bionik 504 putter head.
No need to tip trim any of our putter shafts under normal circumstances. You can just install and then butt trim to length.
What is the inner diameter of this shaft so that I can determine how large the post needs to be?
The shaft will go over a .325 post (which is quite standard)
Is shaft smooth or stepped
This putter shaft is stepped. Every putter shaft on our site that doesn't say "stepless" is a stepped shaft.
