The Apollo Single Bend 36" putter shaft works for a putter with a 90 degree hosel (or post), and creates no offset. This means if you have a putter head with a hole drilled straight down from the putter head, this shaft should work for you, especially if you are not looking for offset. If you do want offset (two more bends in the shaft so that the shaft is ahead of the putter face)then please look at our triple bend putter shaft. Because this is a putter shaft with only one bend in it, it works for both right and left handed putter heads. This is a .370 parallel tip putter shaft.
Technical Specifications
36" raw length
Product Questions
Customer Questions
I'll need a extention for this shaft. What do you recommend.
This one would work well: Steel Shaft Extender for .600 Steel Shafts
What is the weight of this? And is it stepless?
115 grams. It's a stepped shaft.
Basic question, but are there trimming instructions for this shaft? Not sure if I should trim any amount from the tip or butt trim only. I'll be installing in the Bionik 504 putter head.
No need to tip trim any of our putter shafts under normal circumstances. You can just install and then butt trim to length.
What is the angle of the bend?
75 degrees
What is the inner diameter of this shaft so that I can determine how large the post needs to be?
The shaft will go over a .325 post (which is quite standard)
Is shaft smooth or stepped
This putter shaft is stepped. Every putter shaft on our site that doesn't say "stepless" is a stepped shaft.
