The Apollo Black Triple Bend Putter Shaft is a beautiful non-glare black matte finish shaft that is intended for 90 degree bore hole putter heads. (this black shaft is not recommended for putter heads where the shaft goes over a post). So if you have a putter head with a hole drilled straight down from the putter head, and the hole is for a .370 shaft, this shaft will work for you. However, if you have a putter head with a hole drilled at an angle into the putter head, this shaft is NOT the shaft you want.
More information about a "triple bend" putter shaft: This shaft may have a butt label that describes it as “Double Bend (offset + lie)”, but this is more commonly known as a triple bend by putter manufacturers, lie angle being the third bend. In other words, straight up from the 90 degree hole, one bend to create offset, one bend up, and one bend toward the player to create a standard putter lie angle.
Raw length on this shaft is 35". If this black putter shaft works for your application, it makes for an awesome look!
Product Questions
Customer Questions
Basic question, but are there trimming instructions for this shaft? Not sure if I should trim any amount from the tip or butt trim only. I'll be installing in the Bionik 504 putter head.
No need to tip trim any of our putter shafts under normal circumstances. You can just install and then butt trim to length.
Is shaft smooth or stepped
This putter shaft is stepped. Every putter shaft on our site that doesn't say "stepless" is a stepped shaft.
What is the lie angle created by this shaft? and also What is the offset created by this shaft?
